5. PACKAGING
MIL-K-70606 (AR)
5.1 Level A. Packaging shall be in accordance with Special
Packaging Instructions PL2011860.
5.2 Level B. Packaged as specified in 5.1.
5.3 Level C. Packaged as specified in 5.1.
6. NOTES
6.1 Intended use. The M9 Multipurpose Bayonet System is intended for use as a bayonet, field craft knife, combat knife and wire cutter.
6.2 ordering data. Acquisition documents should specify the following:
a. Title, number and date of this specification and all applicable Quality Assurance Provisions (QAPs).
b. Quantity required and delivery schedules. c. Serialization requirements, if applicable.
d. Quality Conformance Inspection, if other than specified in Section 4 of specification.
e. Level of packaging (see section 5).
f. Certificates of conformance for each lot or shipment of product.
g. The packages opened for-examination shall be repackaged by the contractor at the contractor's expense.
h. Disposition of MPBS.
i. Responsibility for test facilities and operation procedures.
6.3 Inspection equipment design. Design responsibility for all inspection equipment is assigned to the contractor. Contractor designs are required for all inspection equipment and may include commercial equipment which the contractor proposes to use. (Commercial equipment is defined as unmodified equipment which is cataloged and available for purchase by the general public). Contractor designs shall include appropriate operating instructions, calibration procedures and maintenance procedures. Commercial equipment shall be fully described by catalog listings or other means which provide sufficient information to permit identification and evaluation by the Government and may include
20
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business