MIL-S-45527A(WC)
*
4.1 Responsibility for inspection. Unless otherwise specified in
the contract or purchase order, the supplier is responsible for the per-
formance of all inspection requirements as specified herein. Except as
otherwise specified in the contract or order, the supplier may use his
own or any other facilities suitable for the performance of the inspec-
tion requirements specified herein, unless disapproved by the Government.
The Government reserves the right to perform any of the inspections set
forth in the specification where such inspections are deemed necessary
to assure supplies and services conform to prescribed requirements.
4.2 Quality assurance terms and definitions. Quality assurance
terms and definitions used herein are in accordance with MIL-STD-109.
*
4.3 Classification of inspection. The inspection requirements
specified herein are classified as follows:
a. First article inspection (see 4.4).
b. Quality conformance inspection (see 4.5).
*
4.4 First article inspection. The first article (initial production
unit(s) )shall be submitted for inspection in accordance with the contract
(see 6.2). The first article shall be representative of the production
processes to be used during quantity production. The first article shall
be subjected to quality conformance inspection specified herein and such
other inspection as is necessary to determine compliance with the require-
ments of the contract.
4.5 Quality conformance inspection.
*
4.5.1 Inspection lot. Unless otherwise specified, the formation,
size and presentation of inspection lots shall be in accordance with MIL-
STD-105 and MIL-W-13855.
*
4.5.2 Examination of springs shall be as specified herein and in
MIL-W-13855. The examination provisions should be applied at the earliest
practical point in manufacture at which it is feasible to inspect for
acceptance without risk of chance in the characteristic by subsequent oper-
at ions. Reinspection of these characteristics on the completed product
is not required provided assurance exists that the characteristic has not
been changed, degraded or damaged by subsequent manufacturing, assembly
or handling and that adequate inspection records are maintained.
*
4.5.2.1 Classification of defects. Classification of defects and
acceptable quality levels (AQL's) for examination in accordance with MIL-
STD-105 shall be as specified herein and shall include the following
provisions:
a. Unless otherwise specified, AQL's apply to each listed
characteristic.
4
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business