MIL-S-45527A(WC)
Where "Visual" is specified as the inspection method
b.
for protective coating, the coating shall be visually
examined for completeness, uniformity in appearance~
scratches, and worn or bare spots.
c.
Where "Visual" is specified as the method for dimensional
or other general drawing characteristics, the characteristic
shall be either scaled or compared with a specimen of
known acceptable quality that has been established as an
inspection standard, for conformance to the requirements
of the drawing.
Where "SMTE" (Standard Measuring and Test Equipment) is
d.
specified as the method of inspection the contractor
may use any type of industry-developed, commercially
available, multi-usage equipment or special inspection
and/or testing equipment approved by the Government,
*
4.5.2.1.1 Springs. Springs shall be examined in accordance with
the classification of defects, as applicable, In Table I.
Table I
Inspection
Class
AQL
Characteristics
Method
None defined
Critical:
Major:
101
Outside diameter - incorrect (3.2)
0.65
SMTE
SMTE
Inside diameter - incorrect (3.2)
102
0.65
SMTE
Free length - not as specified (3.2)
103
0.65
SMTE
Solid height - incorrect (3.2.7)
104
0.65
Direction of helix - not as specified
105
0.65
Visual
(3.2.2)
SMTE
Pitch of strands - incorrect (3.2.3)
0.65
106
(3.2.4)
107
End Construction - incorrect (3.2.5)
0.65
SMTE
0.65
108
Pitch of coils - incorrect or not
SMTE
uniform (3.2.6) (3.2.6.3.)
protective Finish - missing or de-
109
0.65
Visual
fective (3.2)
Minor:
2.5
Marking - incorrect or missing (3.4)
201
Visual
4.0
workmanship (3.5)
202
Visual
4.5.3 Testing.
*
4.5.3.1 Failure data. Unless otherwise specified herein, all tests
shall be conducted on complete springs. If test requirements cited here-
in are not met, acceptance of the springs shall be deferred and the con-
tractor shall accomplish as applicable, the following actions:
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business