MIL-DTL-45500E
3.9 Marking. Guns and parts shall be clearly marked in
accordance with the applicable drawings and MIL-W-13855. Each
gun shall be identified by serial numbers assigned, or approved,
by the procuring activity (see 6.2).
3.10 Workmanship.
Workmanship shall be in accordance with
MIL-W-13855.
4.
VERIFICATION.
4.1 General provisions. Unless otherwise specified in the
contract or purchase order, the supplier is responsible for the
performance of all inspection requirements as specified herein.
Except as otherwise specified in the contract or order, the
supplier may use his own or any other facilities suitable for the
performance of the inspection requirements specified herein,
unless disapproved by the Government. The Government reserves
the right to perform any of the inspections set forth in the
specification where such inspections are deemed necessary to
assure supplies and services conform to prescribed requirements.
4.2 Terms and definitions. Quality assurance terms and
definitions used herein are in accordance with ANSI/ASQC A8402.
4.3 Classification of inspection. The inspection
requirements specified herein are classified as follows:
a.
First article inspection (see 4.4).
b.
Conformance inspection (see 4.5).
4.4 First article inspection. The first article (initial
production unit(s)) shall be submitted for inspection in accordance
with the contract (see 6.2). The first article shall be representative
of the production processes to be used during quantity production.
The first article shall be subjected to the conformance inspection
specified herein and in the applicable specification sheet, and such
other inspections as necessary to determine that all requirements
of the contract have been met.
4.5
Conformance inspection.
4.5.1 Inspection lot. Unless otherwise specified (see 6.1)
the formation, size, and presentation of inspection lots shall be
in accordance with ANSI/ASQC Z1.4 and MIL-W-13855. Guns shall be
assembled from component parts that have met all inspection
requirements specified herein. Endurance test lot size shall be
as specified in 4.5.3.4.1.
4.5.2
Examination.
8
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business